| 1. | P6 _ white pencil to give high light and part lines
用白色的色阏剐加上光影和分模 |
| 2. | Parting line locks are recommended for all molds
琐模块所有的模具都需要。 |
| 3. | Parting line locks are required on all molds
琐模块所有的模具都需要。 |
| 4. | Parting line at the acceptable surface
合模分布在合理可接受的表面。 |
| 5. | Parting lines of the mould not entirely locked
模具分型面未完全锁住 |
| 6. | Ocpl off center parting line
远离中心部分线队列 |
| 7. | Mould halves requiring accurate alignment of core and cavity , and shut off should have appropriate part line locks
上、下模需要精确配合或有擦位的地方，模具一定要有直身锁。 |
| 8. | There ' s an undercut at this position and it needs a slider . it will also have a parting line on this side , is that ok
产品的这个位置不能出模，我们打算做行位，在此面上会有分模线，你接受吗？ |
| 9. | The optimization parting direction was determined after all undercut features were distinguished , and the parting line and parting surface were confirmed accordingly
通过侧凹特征的判别确定模具的优化脱模方向，并确定模具的分型线和分型面。 |
| 10. | The ports of cylinder head were measured with digitized measurement technique , and obtained data were treated under the condition of cad to determine the curve parting line of their toolings
通过对气道进行数字化测量，在cad环境下对获得的数据进行处理，确定其成型模具分型曲面。 |
